                Latest News:
                        
New 3 port RS 232 / 485 Buffered Hub allows two masters to access one slave ( Protocol Independent ) !
Economical RS-485 to dual port Fiber Optic Converter is now available !
RDC's single to multi-mode Fiber Optic Converter now runs up to 20mbps !
Run full-duplex fiber optic ethernet on a single cable with our RDC EnetFOW

rdc232fo - RS-232 to Fiber Optics Converter (Multi-mode)

- Isolates and converts between optical and RS-232 signals
- Intrinsic isolation at fiber side
- Various isolation options available
- 3-wire operation (TX, RX, GND) at RS-232 side
- Protocol Independent

Introduction
Signal
Order Codes
Part Number & Description
Downloads

RS 232 | FO MM | Baud 115K | -20C | +65 C

	Signal 1	Signal 2
Signal Type	RS-232C/D/E	Single-Mode Fiber Optic
Signals Isolated	Txd, Rxd, Sig Gnd	Duplex Fiber - TX RX
Isolation	2500v optical/galvanic	Intrinsically Complete Isolation
Speed	300 - 115K baud
Distance	Typical=15m Max=50m	Typical=2000m Max=4000m
Connector	9-Pin D-Shell or 3-Screw Terminal	ST (bayonet) or SMA (screw)
Fiber Size	NA	62.5/125 50/125 100/300 µm
Wavelength	NA	820 nm
Operating Temp	-20 to +65 DegC (-4 to 150 DegF)
Mounting	DIN Rail Mount (3 styles)
CE Mark Status	Pending

rdc232fo	??	??	??	??
	dv	Input Power: Unregulated 9 to 36v DC (including 12v & 24v battery)
	hv	Input Power: Regulated 48v DC ± 20% (requires '-2p' full isolation)
	av	Input Power: Unregulated 9 to 24v AC or DC
	5v	Input Power: Regulated 5v DC ± 5%
		1p	Non-isolated (RS-232 ground same as power ground)
		2p	Full 2-of-2 ground 2500v galvanic/optical isolation
			st	ST Style Bayonet Optics Connector
				c	3-screw removable terminal
				d	9-pin D-sub shell connector
					cf	Option: Conformal coating, 5000v

Part Number	Description	Stock
rdc232fo-dv-2p-st-d	RS-232 to Fiber Optic Converter, DIN-Rail Mount, 9-36v DC Supply, Full 2-of-2 Ground Isolation, RS-232 by D-Shell Connector, ST bayonet	Yes

- Datasheet
- Manual

Ask a question about this product
Back